Bedienungsanleitung Karcher WPD 50 - Water Dispenser (Seite 10 von 140) (Alle Sprachen)

804777

Zoom out

Zoom in

Vorherige Seite

1/140

Nächste Seite

10 English

Jugs

Rinsing cups

Bottles Cups

Supplementary installation material

Consumables

Filter

Cleaning agent for chemical cleaning

Cleaning agent for cleaning the exterior of the device

Scope of delivery

When unpacking the device, check the contents of the

box for completeness using the operating instructions. If

any accessories are missing or in the event of any ship-

ping damage, please notify your dealer.

Description of the unit

For the illustrations, refer to the graphics page

Illustration A

1Filter cover lock

2Filter cover

3Power switch

4Water connection

5Power supply

6Fuse holder cover with 6 A fuse

7Type plate

8Ventilation openings

9Combination filter

10 Filter holder

11 "Chilled water" button

12 "Unchilled water" button

13 Water dispensing outlet

14 Drip tray

Installation

Connecting the unit

During initial installation and any repairs that involve the

replacement of accessory parts, make sure only parts

approved by KÄRCHER (connection kit, filter, service

cup) are used. These components have been tested

and certified to ensure compliance with KÄRCHER

Quality Standards. No other components may be used.

●The power connection and water input pressure

must correspond to the values in the technical data

(see chapter “Technical data”).

●Depending on local regulations, an approved back-

flow preventer must be installed.

●Set up the unit on a level surface.

●Mains plug and socket must always be freely acces-

sible.

●The trigger, the fuse and the water connection (rear

of the unit) must be freely accessible. The minimum

distance to the wall is 100 mm.

●In the interest of reducing power consumption, the

power supply can be switched off when the unit is

not in use (e.g. using a timer clock).

●Connect the unit only with the hose lines provided.

●Do not use used hose lines.

Connection diagram:

Illustration B

1Socket (fused with 30 mA error-current circuit

breaker)

2Mains cable

3Water dispenser

4Water supply hose (connection kit)

5Pressure reducer with pressure gauge (only neces-

sary with water inlet pressure above 6 bar (0.6

MPa))

6Water tap of the building installation

7Drinking water line of the building installation

8Aqua stop (optional)

9Backflow preventer (optional)

Connections:

Illustration C

1Water connection

2Power supply

3Fuse holder cover with 6 A fuse

4Illuminated trigger

1. Connect the water supply hose to the water connec-

tion “H2O”.

2. Connect the water supply hose to the tap of the

building installation (if necessary, connect additional

components).

3. Connect the mains cable to the power supply.

Inserting the filter

몇WARNING

Health risk through the entry of germs

When installing the filter cartridge, take special care to

ensure hygiene and cleanliness.

Always wear sterile disposable gloves when installing

the filter.

1. Open the filter cover latch.

Illustration D

2. Remove the side filter cover.

3. Remove the service cup that was installed at the

factory.

Illustration E

a Pivot out the filter holder by max. 45°.

b Turn the service cup anticlockwise.

c Remove the service cup.

4. Insert the filter.

Illustration F

a Pivot out the filter holder by max. 45°.

b Insert the filter into the filter holder from above.

c Turn the filter as far as it will go.

The filter is locked.

d Pivot the filter with the filter holder into the device.

5. Fit the side filter cover.

6. Close the filter cover latch.

Initial Start-Up

1. Open the water inlet.

2. Place a container under the water dispensing open-

ing.

3. Press the “Chilled water” button repeatedly until a

flushing time of 5 minutes is reached (approx. 10 -

15 litres).

4. Press the “Unchilled water” button for 1 minute (ap-

prox. 2 litres).

Note

After every 60 seconds of uninterrupted water dispens-

ing, the unit automatically interrupts dispensing.

5. Perform chemical cleaning (see chapter Chemical

cleaning).

The unit is ready for operation.

Description Order no.

Water jug, 1 l, glass, with plas-

tic lid and KÄRCHER logo,

dishwasher safe

6.640-

431.0

Carafe, Eva Solo, 1 l, dish-

washer safe

0.017-

575.0

Description Order no.

Rinsing cup 4 l 6.640-341.0

Description Order

no.

Bottle 0.5 l, made of Tritan,

dishwasher safe

6.640-

430.0

Bottle 0.75 l, made of Tritan,

dishwasher safe

6.640-

512.0

Bottle 0.6 l, with mouthpiece

and lid made of Tritan, dish-

washer safe

6.640-

469.0

High-quality borosilicate glass

bottle 0.75 l, heat-resistant,

clear, Ø 7 cm, height 26 cm

with stainless steel lid and ne-

oprene protective cover

6.642-

186.0

Description Order no.

Hard paper cup, also for hot drinks, 180 ml,

without logo, 2500 pieces

6.640-

455.0

Hard paper cup, also for hot drinks, 180 ml,

with KÄRCHER logo, 2500 pieces

6.640-

460.0

Plastic cup, 200 ml, without logo, 3000

pieces

6.640-

454.0

Plastic cup, 200 ml, with KÄRCHER logo,

3000 pieces

6.640-

453.0

Description Order no.

Error current circuit breaker 30 mA, 230 V,

50 Hz

6.640-

427.0

Aqua stop, leakage water detector with so-

lenoid valve and brass screw connection

G 3/4"

6.640-

291.0

Pressure reducer 1.5 - 6 bar - 1/2 6.640-

625.0

Water Block, flood protection 6.640-

338.0

Backflow preventer, approved 6.640-

463.0

Description Description Order no.

Hy-Pure-Plus filter Combination filter made of active carbon and ultra filter. Retains chlorine, heavy metals and residues from the pipe, retains

bacteria and viruses and ensures good taste. All minerals remain in the water.

2.644-200.0

Description Description Order no.

Cleaning set For containing the chemical cleaning agent (Bevi Tabs alkaline), reusable 2.643-941.0

Bevi Tabs alkaline Chemical cleaning agent for the six-monthly internal cleaning of the WPD, packaging unit 1 x 10 tablets 6.295-891.0

Description Description Order no.

CA 30 R Ready-to-use surface cleaner, 0.5 l bottle 6.295-686.0

Spray head for surface cleaners When you order CA 30 R for the first time, this reusable spray head is required for the spray bottle. 6.295-723.0

Karcher WPD 50 - Water Dispenser Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info