Bedienungsanleitung Karcher WPD 50 - Water Dispenser (Seite 12 von 140) (Alle Sprachen)

804777

Zoom out

Zoom in

Vorherige Seite

1/140

Nächste Seite

12 English

Troubleshooting guide

Warranty

The warranty conditions issued by our relevant sales

company apply in all countries. We shall remedy possi-

ble malfunctions on your appliance within the warranty

period free of cost, provided that a material or manufac-

turing defect is the cause. In a warranty case, please

contact your dealer (with the purchase receipt) or the

next authorised customer service site.

(See overleaf for the address)

Technical data

Subject to technical modifications.

Maintenance plan

Fault Cause Rectification

The device shows "Ready for use" but

does not dispense water. All buttons

are illuminated.

The water supply is interrupted. 1. Ensure a correct water supply.

2. Check the shut-off devices.

3. If the fault persists, contact the service department.

The device is not working. The but-

tons do not light up.

The power supply is faulty. Check the power supply.

The fuse is defective. Remove the cover of the fuse next to the device switch, replace the

fuse. If the fuse blows again, switch off the device, contact the service

department.

The dispensed water is not cooled,

even though the "Chilled water" but-

ton was pressed

The cooling module has not reached its nominal tem-

perature.

1. Wait 20 to 40 minutes and check it again.

If the cooling function exhibits permanent failure:

2. Switch off the device.

3. Contact the service department.

The buttons for chilled and unchilled

water light up alternately and a signal

tone can be heard.

Malfunction in temperature regulation. Contact Service.

WPD 50

Device performance data

Working voltage of the battery V 220-240

Power frequency Hz 50

Power protection (slow-blowing) A 6

Max. power input W 200

Water supply pressure MPa

(bar)

0,15 -

0,6 (1,5-

Water supply temperature °C 5-30

Ambient temperature °C 5 - 32

Water dispenser (depending on supply pressure

and filter status)

Chilled water l/h 120

Unchilled water l/h 120

Min. temperature of chilled water °C 6

Dimensions and weights

Width mm 300

Depth mm 440

Height mm 395

Weight kg 19

Time & date Performed

Daily Remove and clean the drip tray.

After an overnight device standstill, dispense 0.5 l of each type of water and dispose of it.

Weekly, more often if neces-

sary

Clean the outside of the device, clean the drip tray with hot water or in a dishwasher.

Do not use cleaning agents containing alcohol, acidic components or scouring agents for cleaning plastic surfaces.

Half-yearly If the water quality is bad, replace the Hy-Pure-Plus filter.

Perform chemical cleaning, see chapter Chemical cleaning.

Annually Replace Hy-Pure-Plus filter.

The decisive factor for the filter change interval is the amount of water dispensed and the water quality of the inlet water.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Karcher WPD 50 - Water Dispenser Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info