Bedienungsanleitung Kenwood TS-870S (Seite 73 von 104) (Englisch)

606693

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

USB

VOX AGC AUTO

USB

AGC AUTO

11 OPERATOR CONVENIENCES

DRU-3 DIGITAL RECORDING SYSTEM

(OPTIONAL)

The DRU-3 DRS unit allows you to record

approximately 15 seconds of audio per channel on up to

4 channels. The audio is input via your transceiver

microphone. Once recorded, the audio can then be

transmitted. It is also possible to make longer

messages by consecutively sending the contents of

message memories. Finally, you can even send this

longer linked message repeatedly by using the Repeat

function accessible via Menu No. 39 (REPEAT).

The DRU-3 is useful in many situations:

• DX chasing or contest operation where repeated

calls are necessary for extended periods of time

• Checking interference complaints to other equipment

(lets you be in two places at one time)

• Checking or adjusting your transmit signal or your

antennas if it’s not convenient to be sitting in front of

your microphone

• Helping a friend adjust his antenna or receiver when

he needs repeated test transmissions from you

Once you begin using the unit, you’ll likely discover

other applications.

RECORDING MESSAGES

To record a message, you must select the same mode

for transmit and receive. The selected mode must be

SSB, FM, or AM.

Note:

◆

Pressing the

[ ]

(POWER) switch while recording or playing

back messages may cause previously recorded messages or

recordings in progress to be erased.

◆

Refer to “INTERNAL ADJUSTMENTS” {page 70} for information

on adjusting the recording level.

1 Switch OFF the VOX function by pressing [VOX].

2 Press [REC] to activate the Record Standby mode.

• “AP - -” appears.

• Press [CLR] to exit from the Record Standby

mode and to abort recording your message. This

does not erase any previously recorded

messages.

3 Press and hold down [CH 1], or [CH 2], or [CH 3], or

[CH 4] and begin speaking into your microphone.

• There are four memories for recording

messages. Press the button that corresponds to

the message memory that you want to use.

4 Release the button pressed in Step 3 when you

have finished recording your message.

•Recording continues until you release the key or

the maximum recording time passes (about

15 seconds) whichever occurs first.

Note:

To erase a message, use the above recording procedure

without speaking into the microphone (or disconnect your

microphone) while recording.

MESSAGE PLAYBACK

This section explains how to play back the contents of a

single message memory. Whether checking or actually

transmitting messages, press [CLR] any time you want

to cancel playback. Also, you cannot change the

transceiver frequency while playing back messages.

Note:

Pressing the

[ ]

(POWER) switch while recording or playing

back messages may cause previously recorded messages or

recordings in progress to be erased.

■ Checking Messages

Use this procedure to verify the contents of a

message memory.

1 Switch OFF the VOX function by pressing [VOX].

2 Select SSB, FM, or AM mode by pressing

[LSB/USB] or [FM/AM].

• The transmit and receive modes must be the

same.

3 Press [CH 1], or [CH 2], or [CH 3], or [CH 4] to

play back the message in the respective memory.

• For example, “AP 1 - - - - - -” appears while

Message #1 is playing back.

■ Transmitting Messages (VOX)

Use this procedure to transmit the contents of a

message memory.

1 Switch ON the VOX function by pressing [VOX].

2 Select SSB, FM, or AM mode by pressing

[LSB/USB] or [FM/AM].

• The transmit and receive modes must be the

same.

3 Press [CH 1], or [CH 2], or [CH 3], or [CH 4] to

play back the message in the respective memory.

• After the message is transmitted, the

transceiver automatically returns to the

receive mode.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Kenwood TS-870S Seite 73

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Kenwood TS-870S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info