Bedienungsanleitung MTD Zero Turn Serie Frontcut (Seite 9 von 18) (Englisch)

495078

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite

English Operating Instructions

Symbols used in these

instructions

The following symbols are used

in these instructions:

t~êåáåÖ

vçìê=~ííÉåíáçå=áë=Çê~ïå=íç=Ç~åÖÉêë=áå=

ÅçååÉÅíáçå=ïáíÜ íÜÉ=~Åíáçå=ÇÉëÅêáÄÉÇ=

~åÇ=íÜêçìÖÜ=ïÜáÅÜ=íÜÉêÉ=áë=~=Ç~åÖÉê=

íç éÉêëçåëK

t~êåáåÖ

vçìê=~ííÉåíáçå=áë=Çê ~ïå=íç=Ç~åÖ Éêë=áå=

ÅçååÉÅíáç å=ïáíÜ=íÜÉ=~Åíáçå=ÇÉ ëÅêáÄÉÇ =

ïÜáÅÜ=Åç ìäÇ=áå îçäîÉ =ã~íÉ êá~ä=Ç~ã ~Ö ÉK

Note

Points out important information

and tips concerning application.

Details concerning position

Where a position on, or in relation to,

the unit is described (e.g. left, right),

this is always from the perspective of

the driver, sitting on the driver seat

and facing forward.

Note

Graphical representations can vary

in detail from the appliance which

has been bought.

Note concerning the disposal

of packaging

Any waste packaging or waste

appliances etc. which accumulate

should be disposed of according

to the local regulations.

Assembling the appliance

Note

The assembly of the unit (steering

wheel, seat, bumper, cutter deck

with mounting frame) is described

in a separate assembly manual

(according to the model).

Commissioning the battery

Figure 4a/b

t~êåáåÖ

oáëâ=çÑ=éçáëçåáåÖ=~åÇ=áåàìêó=Ñêçã=

Ä~ííÉêó=~ÅáÇK

tÉ~ê=éêçíÉÅíáîÉ=ÖçÖÖäÉë=~åÇ=ÖäçîÉëK=

aç=åçí=~ääçï=Ä~ííÉêó=~ÅáÇ=íç=ÅçãÉ=áåíç=

Åçåí~Åí=ïá íÜ=í ÜÉ=ëâ áåK=pÜçì äÇ=Ä~ ííÉêó =

~ÅáÇ=ëéä~ëÜ=áåíç=óçìê=Ñ~ÅÉ=çê=ÉóÉëI=

ï~ëÜ=áããÉÇá~íÉäó=ïáíÜ=ÅçäÇ=ï~íÉê=

~åÇ Åçåëìäí=~=ÇçÅíçêK=pÜçìäÇ=óçì=

áå~ÇîÉêíÉåíäó=ëï~ääçï=Ä~ííÉêó=~ÅáÇI=

Çêáåâ= éäÉ åíó =ç Ñ=ï~íÉ ê= ~åÇ =Åç åë ìäí=

~ ÇçÅíçê=áããÉÇá~íÉäóK=píçêÉ=Ä~ííÉêáÉë=

áå=~=ë~ÑÉ=éä~ÅÉ=çìí=çÑ=íÜÉ=êÉ~ÅÜ=

ÅÜáäÇêÉåK=kÉîÉê=íáäí=íÜÉ=Ä~ííÉêóX=

íÜÉ Ä~ííÉêó=~ÅáÇ=ã~ó=êìå=çìíK

_êáåÖ=íÜÉ=êÉã~áåáåÖI=ìåìëÉÇ=Ä~ííÉêó=

~ÅáÇ=íç=óçìê=ÇÉ~äÉê=çê=íç=~=ï~ëíÉ=

Çáëéçë~ä=Åçãé~åóK

t~êåáåÖ

oáëâ=çÑ=ÑáêÉI=Éñéäçëáçå=~åÇ=

Åçêêçëáçå=ÇìÉ=íç=Ä~ííÉêó=~ÅáÇ=

~åÇ Ä~ííÉêó=~ÅáÇ=Ö~ëÉëK

fããÉÇá~íÉäó=ÅäÉ~å=é~êíë=çÑ=íÜÉ=

~ééäá~åÅÉ=ìéçå=ïÜáÅÜ=Ä~ííÉêó=~ÅáÇ=

Ü~ë=ÄÉÉå=ëéê~óÉÇK=_~ííÉêó=Ü~ë=

~ ÅçêêçëáîÉ=ÉÑÑÉÅíK

aç=åçí=ëãçâÉ=~åÇ=âÉÉé=ÄìêåáåÖ=~åÇ=

Üçí=çÄàÉÅíë=~ï~óK=píçêÉ=Ä~ííÉêáÉë=áå=

êççãë=ïÜáÅÜ=~êÉ=ïÉää=îÉåíáä~íÉÇ=~åÇ=

ÇêóK=qÜÉêÉ=áë=~=êáëâ=çÑ=~=éçëëáÄäÉ=ëÜçêí=

ÅáêÅìáí=ïÜÉå=ïçêâáåÖ=ïáíÜ=íÜÉ=Ä~ííÉêóK=

aç=åçí=éä~ÅÉ=~åó=íççäë=çê=ãÉí~ä=

çÄàÉÅíë=çå=íÜÉ=Ä~ííÉêóK

If a “maintenance-free/

sealed” battery (type 1)

is supplied

(Battery without filler plugs)

The battery is filled with battery acid

and is sealed at the factory. However,

even a “maintenance-free” battery

requires maintenance if it is to have

a longer service life.

 Keep the battery clean

 Avoid tipping the battery.

Electrolyte fluid leaks from

a “sealed” battery, if it is tipped.

If an empty battery (type 2)

is supplied

(Battery with filler plugs)

Figure 4b

 Remove the filler plugs of the

battery cells.

 Fill each cell slowly with battery

acid up to 1 cm below the filling

opening.

 Leave the battery to stand for

30 minutes so that the lead can

soak up the battery acid.

 Check the level of the battery acid,

add more if necessary.

 Before using the battery for the first

time, charge it using a battery

charger (max. charging current

12 Volt/6 Ampere) for 2 to 6 hours.

After charging the battery, first

unplug the charger and then

disconnect the battery (see also

the operating instructions for the

battery charger).

 Re-insert the filler plugs of the

battery cells.

 Install the battery in the unit.

 Remove the strip seal from the

battery vent. Connect the venting

hose so that the free end points

downwards in the appliance.

The hose must always allow free

passage!

 First connect the red cable (+),

and then the black cable (–).

 Thereafter, use only distilled water

to top up the battery (check every

2 months).

 Keep the battery clean.

t~êåáåÖ

lÄëÉêîÉ=íÜÉ=çêÇÉê=áå=ïÜáÅÜ=íÜÉ=

Ä~ííÉêó=áë=ãçìåíÉÇ=ïÜÉå=ÅçååÉÅíáåÖL

ÇáëÅçååÉÅíáåÖ=íÜÉ=íÉêãáå~äëK

båëì êÉ =íÜ~ í=íÜ É=Ö ì~ ê Ç=Ñç ê=íÜ É=êÉ Ç=Å~ Ä äÉ =

EHLé ç ëá íá î É= íÉ ê ãáå~äF=áë = Ñáí íÉÇ=ÅçêêÉ Åí äó =

íç=íÜÉ=éçëáíáîÉ=íÉêãáå~äK

Fitting:

 First connect the red cable

(+/positive pole) and then the black

cable (–/negative pole).

Removal:

 First disconnect the black cable

(–/negative pole) and then the red

cable (+/positive pole).

MTD Zero Turn Serie Frontcut Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von MTD Zero Turn Serie Frontcut

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info