Bedienungsanleitung Multiplex ROYALevo12 (Seite 14 von 57) (Englisch)

30266

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

Instructions

Page 69

8.1.2. This is NEW

The battery management in the ROYALevo monitors

the charge status of the transmitter battery during all

operating conditions, even when the transmitter is

switched off.

In detail the following happens:

a. during charging

If the transmitter battery is charged with more

than 50 mA via the charging socket, the charging

current is measured regularly and the charge is cal-

culated. The result is stored in the transmitters

memory..

b. during operation

Also during operation the current is measured and

the drawn charge is calculated and subtracted

from the available charge. In the status display 4

(è 9.6.) the remaining battery charge is shown.

Further the residual operating time is calculated

and displayed. This figure is shown to give a rough

idea of how long the transmitter can be operated

with the power consumption currently measured.

c. when the transmitter is switched off

Also if your transmitter „sleeps“ on the shelf, the

battery loses charge by the effect of self-discharge

(approx. 1.5% per day). The battery management

automatically reduces the available charge accord-

ingly.

Battery charge an residual values are only intended

as a guide. Tolerances and variations between in-

dividual examples, and the effects of battery main-

tenance schedules, can produce considerable dis-

crepancies.

8.1.3. This is what you must attend

To get battery management display as reliable as possi-

ble, please take care of the following:

a. Correction of the indicated battery charge

The battery management assumes a nominal ca-

pacity of 1500 mAh. After the battery has reached

ist full capacity (more than 5 charge/discharge cy-

cles) the true capacity can be set in the menu:

L , Transmitter parameter: Batt. charge

In steps of 50 mAh you can set the capacity meas-

ured by your charger.

If battery voltage of 6.5 V or below is de-

tected, the available charge is set to 0 mAh.

b. Use a suitable charger (èè 8.4.) and charge via

the socket

Only if the battery is charged via the socket the

battery management can work correctly.

c. charging with constant current (1/10 C)

If the battery will be charged longer than calcu-

lated with the formula in chapter 8.4. the battery

management will limit the available charge at

1500 mAh.

8.2. The essentials in brief

• 6 cells, 1500 mAh, NiMH (Nickel-Metal-Hydride)

• Integral thermo-fuse (automatic reset)

• Standard charge (0,1 C = 150 mA) 12 hours

• Fast charge (1 C =1,5 A) = maximum charge current

with automatic cut-off

• Avoid deep-discharging (< 1V/Zelle)

• during longer storage (more than 4 weeks) avoid

temperatures above 30°C

8.3. Safety notes

! The transmitter battery is responsible for supply-

ing power to the transmitter, and therefore

makes a vital contribution to the unit’s opera-

tional security

. For this reason it is very important

that you observe the following instructions on

charging and maintaining the battery.

! The transmitter battery is fitted with a thermo-fuse

with automatic reset which protects the battery

and transmitter from short-circuit, reverse polarity

and excessive current. The transmitter electronics

have no additional fuse! For this reason it is only

permissible

to replace the battery with another

genuine MULTIPLEX transmitter pack!

! Additional safety notes

• Batteries are potentially hazardous, and must be

stored out of the reach of children.

• Before each session check that the battery is in

perfect order. Damaged or defective batteries must

not be re-used.

• Never heat, burn, open or short out batteries. Do

not charge or discharge them at excessive currents,

overcharge or deep-discharge them, nor charge

them with reversed polarity.

• Place batteries on a heat-resistant, non-flammable

and non-conductive surface for charging, and do

not leave them on charge unsupervised.

• Do not make any modifications to the rechargeable

batteries. Never solder or weld direct to the cells.

• If these batteries are mistreated, there is a danger of

fire, explosion, burns and chemical burns. Suitable

extinguishing agents: water, CO2, sand.

• Escaped electrolyte is corrosive!

Do not allow it to contact your skin or eyes. In an

emergency wash the affected area with copious

amounts of water and seek the help of a doctor

immediately.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Multiplex ROYALevo12 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Multiplex ROYALevo12

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info