Bedienungsanleitung Multiplex ROYALevo12 (Seite 55 von 57) (Englisch)

30266

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

ROYAL evo

Page 110

19. Accessories

19.1. Scanner (with HFM-S RF module)

A scanner module can expand the Synthesizer RF mod-

ule HFM-S of the ROYALevo. The scanner can do two

„jobs“:

19.1.1. Scan all frequencies/channels in the band

All channels in the band will be measured sequentially.

Detected signals will show up in the display as bars. The

height of the bar corresponds to the strength of the

signal.

19.1.2. Channel-Check at power-ON

The channel selected for the synthesizer is checked

every time you switch your transmitter ON. If the chan-

nel is occupied already the synthesizer does not start

operation (no RF output) and in the display you will see

a warning. If no signal is detected on your channel,

normal operation starts.

19.1.3. Installation of the scanner module

The user can install the scanner. No tools or adjustments

are required.

Available frequencies/bands: see MULTIPLEX main cata-

logue

19.2. Channel-Check

(with the RF module HFM-4)

A Channel-Check module can be installed in the RF

module HFM-4. This module needs a receiver crystal

with the same frequency/channel, which will be used

for the model.

Every time you switch your transmitter on, the module

checks if the channel is occupied or not.

The Channel-Check module for the ROYALevo is identi-

cal with the module, used in the transmitters PiCO line,

COCKPIT MM and in the RF module HFM3.

Available frequencies/bands: see MULTIPLEX main cata-

logue

19.2.1. Installation of the Channel-Check module

Switch OFF and open the transmitter

remove the RF module

Install the desired receiver crystal in

the Channel-Check module

plug Channel-Check module onto the

RF module

reinstall the unit in the transmitter

19.2.2. Operating Channel-Check

Expand the aerial fully

Switch the transmitter on

LED glows permanently: Channel occupied

LED flashes: Channel free

(without guarantee)

If the channel is occupied the following message ap-

pears in the display:

English text:

! NOTE !

No RF

19.3. Other accessories/spar parts

19.3.1. Overview

Article Order No.

Transmitter bag 76 3322

Transmitter aerial 110 cm 89 3002

Transmitter tray 8 5305

Space-Box ROYALevo BASIC 8 5658

Space-Box matching rainshield 8 5655

Transmitter neckstrap 8 5646

Transmitter Coross-over strap 8 5640

Padded neckstrap cushion 8 5641

Switch 2-position 7 5748

Stick top button/switch (è 19.3.2.) 7 5303

19.3.2. Stick top button/switch

# 7 5303

A stick top button/switch is available

for the ROYALevo with integral but-

ton KTa and switch KSw. Two wires

connect the stick to the main elec-

tronics board. Switch and button

can be assigned to controls and

switches in the same way as all the

other switches are.

Channel-Check

module

KSw '

KSw #

ca. 300 m

Only with

aerial fully expanded!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Multiplex ROYALevo12 Seite 55

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Multiplex ROYALevo12

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info