Bedienungsanleitung Onkyo TX-NR3008 (Seite 66 von 116) (Englisch)

553767

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

Auto Power Down

■ Auto Power Down

` Off:

Auto Power Down disabled.

` On:

Auto Power Down enabled.

When “Auto Power Down” is set to “On”, AV receiver

will automatically perform STANDBY operation if there

is no operation for 30 minutes with no audio and no video

signal input.

“Auto Power Down” will display on the display and OSD

from 30 seconds before the Auto Power Down functions.

Default setting: On (European and Asian models), Off

(North American models)

Note

• Depending on some sources, the auto power-down function may

activate during playback.

• The Auto Power Down function does not work when Zone 2 or

Zone 3 is on.

Network

See “Network Settings” (➔ 76).

Firmware Update

See “Firmware Update” for update procedure (➔ 112).

Note

• Perform the firmware update only when an announcement is

posted on the Onkyo web site. See the Onkyo web site for latest

information.

• It takes about 60 minutes to complete the firmware update.

• (TX-NR5008) When updating a firmware from a USB mass

storage device, the AV receiver searches the device which is con-

nected earlier during power on. If two devices have been con-

nected at the time of power on, the AV receiver will search the

device on the front panel.

■ Version

The current version of the firmware is displayed.

■ Receiver

` via NET:

You can update the firmware via Internet. Check the

network connection before update.

` via USB:

You can update the firmware from a USB mass stor-

age device.

You can update the AV receiver’s firmware. Do not shut-

down the power of the AV receiver while update.

■ Universal Port

` via NET:

You can update the firmware via Internet. Check the

network connection before update.

` via USB:

You can update the firmware from a USB mass stor-

age device.

You can update the Onkyo dock’s firmware. Do not shut-

down the power of the AV receiver while update.

Note

• This update shall not be performed when no dock is connected

to UNIVERSAL PORT jack.

With this preference, you can protect your settings by

locking the setup menus.

Main menu Lock Setup

■ Setup

` Locked:

Setup menus locked.

` Unlocked

Setup menus not locked.

When the setup menus are locked, you cannot change any

setting.

You can change various audio settings from the Home

menu (➔ 30).

Note

• These settings are disabled when the “Audio TV Out” setting is

set to “On” (➔ 64) and an input selector other than HDMI is

selected.

Tone Control Settings

You can adjust the bass for the front, front wide, front

high, center, surround, surround back and subwoofer

speakers and treble for the front, front wide, front high,

center, surround and surround back speakers, except when

the Direct, Pure Audio or THX listening mode is selected.

■ Bass

` –10dB to 0dB

to +10dB in 2 dB steps.

You can boost or cut low-frequency sounds output.

■ Treble

` –10dB to 0dB

to +10dB in 2 dB steps.

You can boost or cut high-frequency sounds output.

Operating on the AV receiver

Lock Setup

Using the Audio Settings

Press RECEIVER followed by HOME.

Use q/w to select “Audio”, and then use q/w/e/r

to make the desired selection.

Press TONE on the AV receiver repeatedly to

select either “Bass” or “Treble”.

Use Up r and Down e on the AV receiver to

adjust.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR3008 Seite 66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR3008

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info