Bedienungsanleitung Onkyo TX-NR414 (Seite 46 von 128) (Englisch)

492644

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

Advanced Operations

En-46

Menu Audio Adjust

With the Audio Adjust functions and settings, you can

adjust the sound and listening modes as you like.

Multiplex/Mono

■ Multiplex

Input Ch (Mux)

` Main

` Sub

` Main/Sub

This setting determines which channel of a stereo

multiplex source is output. Use it to select audio channels

or languages with multiplex sources, multilingual TV

broadcasts, and so on.

■ Mono

Input Ch (Mono)

` Left+Right

` Left

` Right

This setting specifies the channel to be used for playing

any 2-channel digital source such as Dolby Digital, or 2-

channel analog/PCM source in the Mono listening mode.

Dolby

■ PL II Music (2ch Input)

These settings apply to only 2-channel stereo sources.

Panorama

` On

` Off

With this setting, you can broaden the width of the front

stereo image when using the Dolby Pro Logic II Music

listening mode.

Dimension

` –3 to 0

to +3

With this setting, you can move the sound field forward or

backward when using the Dolby Pro Logic II Music

listening mode. Higher settings move the sound field

backward. Lower settings move it forward.

If the stereo image feels too wide, or there’s too much

surround sound, move the sound field forward to improve

the balance. Conversely, if the stereo image feels like it’s

in mono, or there’s not enough surround sound, move it

backward.

Center Width

` 0 to 3

to 7

With this setting, you can adjust the width of the sound

from the center speaker when using the Dolby Pro Logic II

Music listening mode. Normally, if you’re using a center

speaker, the center channel sound is output from only the

center speaker. (If you’re not using a center speaker, the

center channel sound will be distributed to the front left

and right speakers to create a phantom center). This setting

controls the front left, right, and center mix, allowing you

to adjust the weight of the center channel sound.

DTS

■ Neo:6 Music

Center Image

` 0 to 2

to 5

With this setting, you can specify by how much the front

left and right channel output is attenuated in order to create

the center channel.

Changing the value from “0” to “5” will spread the sound

of the center channel to left and right (outwards).

Theater-Dimensional

■ Listening Angle

` Wide:

Select if the listening angle is 40 degrees.

` Narrow:

Select if the listening angle is 20 degrees.

With this setting, you can optimize the Theater-

Dimensional listening mode by specifying the angle of the

front left and right speakers relative to the listening

position. Ideally, the front left and right speakers should be

equidistant from the listening position and at an angle close

to one of the two available settings.

Audio Adjust

1 2 3 4 5

“Setup”

20°/40°

Front left speaker Front right speaker

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR414 Seite 46

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR414

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info