Bedienungsanleitung Onkyo TX-NR929 (Seite 69 von 160) (Englisch)

517568

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

Advanced Operations

En-69

Operating

procedure

(➔ page 61)

Tip

• Sounds processed by Digital Processing Crossover

Network are played.

• You can switch from the current audio source to test noises

by pressing MODE/D (Blue).

■ High Distance, Low Distance

` 0inch(0.0cm)

to 12inch(30.0cm) in 1 inch

(2.5 cm) steps.

With this setting, you can adjust the virtual position of

tweeter and woofer units. Adjusting “High Distance”

virtually shifts woofers behind tweeters. Adjusting

“Low Distance” virtually shifts tweeters behind

woofers.

Tip

• Sounds processed by Digital Processing Crossover

Network are played.

• You can switch from the current audio source to test noises

by pressing MODE/D (Blue).

With the Audio Adjust functions and settings, you can

adjust the sound and listening modes as you like.

Multiplex/Mono

■ Multiplex

Input Channel

` Main

` Sub

` Main/Sub

This setting determines which channel of a stereo

multiplex source is output. Use it to select audio

channels or languages with multiplex sources,

multilingual TV broadcasts, and so on.

■ Mono

Input Channel

` Left + Right

` Left

` Right

This setting specifies the channel to be used for

playing any 2-channel digital source such as Dolby

Digital, or 2-channel analog/PCM source in the Mono

listening mode.

Output Speaker

` Center

Mono audio is output by the center speaker.

` Left / Right:

Mono audio is output by the front left and right

speakers.

This setting determines which speakers output mono

audio when the Mono listening mode is selected.

Note

• If the “Center” setting is set to “None” (➔ page 65), this

setting cannot be selected.

Dolby

■ PL IIx Music (2ch Input)

These settings apply to only 2-channel stereo

sources.

If you’re not using any surround back speakers, these

settings apply to Dolby Pro Logic II, not Dolby Pro

Logic IIx.

Panorama

` On

` Off

With this setting, you can broaden the width of the

front stereo image when using the Dolby Pro Logic IIx

Music listening mode.

Dimension

` –3 to 0

to +3

With this setting, you can move the sound field

forward or backward when using the Dolby Pro Logic

IIx Music listening mode. Higher settings move the

sound field backward. Lower settings move it forward.

If the stereo image feels too wide, or there’s too much

surround sound, move the sound field forward to

improve the balance. Conversely, if the stereo image

feels like it’s in mono, or there’s not enough surround

sound, move it backward.

Center Width

` 0 to 3

to 7

With this setting, you can adjust the width of the

sound from the center speaker when using the Dolby

Pro Logic IIx Music listening mode. Normally, if you’re

using a center speaker, the center channel sound is

output from only the center speaker. (If you’re not

using a center speaker, the center channel sound will

be distributed to the front left and right speakers to

create a phantom center.) This setting controls the

front left, right, and center mix, allowing you to adjust

the weight of the center channel sound.

(Low Distance)

Tweeter

Woofer

(High Distance)

Distance Distance

3. Audio Adjust

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR929 Seite 69

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR929

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info