Bedienungsanleitung Onkyo TX-NR929 (Seite 67 von 160) (Englisch)

517568

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

Advanced Operations

En-67

Operating

procedure

(➔ page 61)

Note

• These settings cannot be calibrated when the AV receiver

is muted.

• Speakers that you set to “No” or “None” in

“Speaker Configuration” cannot be selected (➔ page 65).

• When the “Powered Zone 3” setting is set to “Yes”

(➔ page 65) while Powered Zone 2 is enabled

(➔ page 84), the surround back speakers cannot be used.

• When the “Speakers Type(Front)” setting is set to

“Bi-Amp” or “Digital Crossover” while Powered Zone 2 is

enabled (➔ page 84), the surround back speakers cannot

be used.

• The test tone is output at the standard level for THX, which

is 0 dB (absolute volume setting 82). If you normally listen

at volume settings below this, be careful because the test

tone will be much louder.

For the center speaker and subwoofer, the level settings

made by using the Quick Setup are saved in this menu

(➔ page 59).

Tip

•

If you’re using a handheld sound level meter, adjust the level

of each speaker so that it reads 75 dB SPL at the listening

position, measured with C-weighting and slow reading.

Equalizer Settings

With the Equalizer settings, you can adjust the tone of

speakers individually with a 7-band equalizer. The

volume of each speaker can be set.

■ Manual Equalizer

` On:

You can adjust the equalizer for each speaker

manually. Continue with the following procedure:

` Off

Tone off, response flat.

Note

• When the Direct or Pure Audio listening mode is selected,

the equalizer settings have no effect.

• If “Audyssey” is enabled, it prevails over this setting

(➔ page 71).

THX Audio Setup

■ Surr Back Speaker Spacing

` <1ft (<0.3m)

` 1ft-4ft (0.3m-1.2m)

` >4ft (>1.2m)

You can specify the distance between your surround

back speakers.

Note

• Cannot be set if:

–“Surround Back” is set to “None” (➔ page 65).

–“Surround Back Ch” is set to “1ch” (➔ page 66).

–The “Powered Zone 3” setting is set to “Yes”

(➔ page 65) while Powered Zone 2 is enabled

(➔ page 84).

–The “Speakers Type(Front)” setting is set to “Bi-Amp” or

“Digital Crossover” while Powered Zone 2 is enabled

(➔ page 84).

■ THX Ultra2/Select2 Subwoofer

` No

` Yes

If you’re using a THX-certified subwoofer, set this

setting to “Yes”.

Note

• If the “Subwoofer” setting is set to “No”, this setting cannot

be selected (➔ page 65).

■ BGC

` Off

` On

If your listening room layout (for practical or aesthetic

reasons) locates most of the listeners close to the

rear wall, the resulting bass level can be sufficiently

reinforced by the boundary that the overall sound

becomes “boomy”. THX Select2 Plus receivers

contain a Boundary Gain Compensation (BGC)

feature to improve bass balance.

Note

• This setting is only available if “THX Ultra2/Select2

Subwoofer” is set to “Yes”.

• If the “Subwoofer” setting is set to “No”, this setting cannot

be selected (➔ page 65).

■ Loudness Plus

` Off

` On

When the “Loudness Plus” setting is set to “On”, it is

possible to enjoy even subtle nuances of audio

expression at low volume. This is only available when

the THX listening mode is selected.

Press w to select “Channel”, and then use

e/r to select a speaker.

Use q/w to select a frequency, and then use

the e/r to adjust the level at that frequency.

The volume at each frequency can be adjusted

from –6dB to 0dB

to +6dB in 1 dB steps.

Tip

• You can select: “63Hz”, “160Hz”, “400Hz”, “1kHz”,

“2.5kHz”, “6.3kHz”, or “16kHz”. And for the subwoofer,

“25Hz”, “40Hz”, “63Hz”, “100Hz”, or “160Hz”.

• Low frequencies (e.g., 63 Hz) affect bass sounds; high

frequencies (e.g., 16 kHz) affect treble sounds.

Use q to select “Channel”, and then use e/r

to select another speaker.

Repeat steps 1 and 2 for each speaker.

You cannot select speakers that you set to “No”

or “None” in the “Speaker Configuration”

(➔ page 65).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Onkyo TX-NR929 Seite 67

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Onkyo TX-NR929

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info