Bedienungsanleitung Sangean U5DBT (Seite 5 von 16) (Englisch)

797386

Zoom out

Zoom in

Vorherige Seite

1/16

Nächste Seite

Charging the batteries

Make sure the radio is switched off and connected to the

AC mains socket.

When the battery charge indicator LED ashes green, this

indicates the batteries are charging. Batteries will be fully

charged in around 5-7 hours. The battery charge indicator

LED shows steady green light when the battery charging

process is complete.

NOTE

Duration for charging your batteries fully can vary

according to the mAh capacity of the batteries. Higher

mAh batteries require longer charging time.

IMPORTANT

Under some conditions the charging LED indicator

may switch off after flashing briefly. This may happen

if the batteries are already freshly charged, or if the

radio detects that you may be attempting to recharge

alkaline batteries or mixed different types or capacity of

rechargeable battery. In these cases the charging will be

stopped.

Important Information On Charging And

Using Rechargeable Batteries

1. Recharge the batteries in any case at least every 2

months.

2. Make sure the Battery Select switch next the battery

compartment is set to the “CHARGE NiMH ON”

position.

3. Put the batteries in the compartment whilst paying

attention to the correct polarity of the batteries (+ and -).

4. First use: Charge new batteries in one continuous,

uninterrupted, charge until they are full. This first

charge may take longer than normal. For longer

battery life it is advised to always recharge in one

continuous, uninterrupted charge until batteries are

full and to not recharge again whilst the batteries are

still full.

5. New batteries will only reach their full capacity

after some time of use (several charge – discharge

cycles).

6. Leave the complete group of batteries in place inside

the radio and do not use these batteries or a few

of them for other purposes. This will result in a mix

of (fully) charged and (partly) empty batteries. This

can seriously damage the batteries and radio when

recharged.

7. It is advised to only charge batteries at room

temperatures between 5 degrees C – 35 degrees C.

In lower or higher temperatures full charge cannot be

achieved.

8. Depending on the capacity of the batteries, charging

from “empty” to “full” can take several hours, even up

to 7 hours or more.

9. Do not charge batteries when the radio is hot or

exposed to heat or heat sources.

10. It is advised to clean the metal contacts of the

batteries and of the charger inside the radio e.g. with

a contact-spray from time to time.

11. Do not use a mix of old and new rechargeable batteries.

12. Do not use a mix of rechargeable and nonrechargeable

batteries.

13. Do not use a mix of full and empty rechargeable

batteries.

14. Do not use batteries that have a different mAh capacity.

15. Do not use damaged, deformed or leaking batteries.

16. Battery level indication is an approximate indication

only and can vary with battery type used.

17. Batteries can become hot during charging.

18. In cold conditions the capacity of batteries will

be much lower than when used at normal room

temperature.

19. Batteries (even when supplied with the radio), as

being consumables, do not fall under the warranty

conditions of the radio.

20. Batteries should not be disposed of by incineration

and with household waste.

21. Disposable batteries should be taken to a suitable

recycling centre if possible.

22. CAUTION

Danger of explosion if battery is incorrectly

replaced. Replace only with the same or equivalent

type.

Battery charging indicator

Please note that the battery charging status detection can

only be activated when the radio is in charging mode (i.e. the

radio is switched off, the battery switch slides to the NiHM

position and it is connected to the AC mains socket).

1. When charging is in progress,

Battery 123456

Charging

display is shown at right and the

charging indicator LED flashes

green.

2. When the charging process is

Battery 123456

Capacity

completed, display is shown at

right and the charging indicator

LED lights in steady green.

3. If batteries are already fully

Battery Full

charged, display is shown at right

and it will switch to standby mode

after 5 seconds.

4. When there is no battery / missing

No cell

batteries in the compartment or

some of batteries are inserted with the incorrect

polarity, display is shown at right and it will enter

standby screen after 5 seconds.

NOTE

If a battery is removed while charging, display is shown

at right and the charging indicator LED lights red.

5. During the charging process, if a

Battery 123456

Error

battery is detected as faulty /

damaged, a solid square will be

displayed under the corresponding battery number (see

picture right) and the charging indicator LED ashes red.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sangean U5DBT Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Sangean U5DBT

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info