Bedienungsanleitung Sanibroyeur SANICUBIC 2 Classic Expert-line (Seite 8 von 49) (Alle Sprachen)

532739

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

ALARM OPERATION

1/ General alarms:

High level alarm:

If the water level in the unit is abnormally high: the buzzer is

triggered and the red LED comes on; the other motor starts up

3 seconds later (see the illustration showing the control

keyboard).

Temporary alarm:

If one of the 2 motors runs for more than 1 minute: the buzzer is

triggered and the red alarm LED comes on; the other motor starts

up 3 seconds later.

2/ Resetting the general alarms:

If the problem that has triggered one of the alarms referred to

above ceases, the buzzer stops, but the red alarm LED stays

on to memorize the fact that the system has met with a

problem.

The “Reset alarm” key on the keyboard is used to switch the

buzzer off in all cases, but it only switches the red LED off if

the problem that triggered the alarm has been dealt with. This

avoids the risk of having a system “abandoned” in fault status.

UNIT ALARM

DRAINING

The SANICUBIC

Classicunit is fitted with 2 plugs ( ).

Disconnect the unit from the power supply.

To drain the unit

1- Unclip the cover.

2- Remove one of the 2 plugs.

3- Insert a wet utility vacuum cleaner pipe to drain the unit. The

port diameter is 40 mm.

4- When the unit has been drained, put

the plug and then the cover back in place.

FIXING THE SANICUBIC UNIT TO THE FLOOR

The SANICUBIC

Classicunit is equipped with fittings to hold it

on the floor and

prevent it from turning or moving.

1- Place the unit on the desired spot.

2- Draw the outline of the unit.

3- Position the brackets and fix them to the floor as shown on the

template diagram ( ).

4- Put the unit back in place.

5- Fix the unit in place with the screws.

ELECTRICAL CONNECTIONS

1- The electrical installation work must be carried out by a

qualified electrician.

The electrical installation must comply with the standards in

force in the country concerned

2- The power supply must be of the class 1 type. The unit must be

connected via an earthed connection box. The electric power

circuit must be protected by a high-sensitivity 30 mA differential

circuit breaker set at 20 A. The connection must be used solely

to power the

SANICUBIC

Classic

. If the power lead on the unit

is damaged, it must be replaced by the manufacturer or its

after-sales service to avoid all danger.

motor 1

LED

motor 2

LED

“Alarm”

LED

“Mains”

LED

motor 1

“Override”

motor 2

“Override”

“RESET”

Alarm

CONFORMITY WITH STANDARDS

• SANICUBIC

Classiccomplies with standard EN 12050-1 (lift

station for household waste containing faeces) and with the

European directives covering construction products, electrical

safety and electromagnetic compatibility

This unit must be installed and used in compliance with

European installation standard EN12056 and with local

requirements.

COMMISSIONING

1- Once the plumbing and electrical connections have been

made, check that the connections are watertight by

letting water flow successively through each inlet used.

Make sure that the unit is operating correctly by carrying

out at least two start cycles with water to test the system.

2 -

WARNING! Do not operate the motors in override

status (by pressing the pushbuttons

on the control box) until the pumps have been filled

with water. Operation without water damages the

maceration system.

USE

1- The SANICUBIC

Classic unit is designed to drain off

household waste water. Any other use will invalidate the

guarantee. Do not dispose of sanitary towels, condoms,

hygiene articles, oils, solvents, acids, or any other poten-

tially corrosive or explosive liquids etc., via the unit.

WARNING: In the event of a power failure, stop

draining any water from the equipment connected

to the SANICUBIC

Classic unit.

3- Do not install or use the unit in a zone where there is a

risk of explosion.

GUARANTEE

The SANICUBIC

Classic unit is guaranteed for two years

(parts and labour) provided that it has been installed and

used in compliance with the present instructions.

MAINTENANCE

A visual check of the lift station must be made once a month

to make sure it is operating correctly, and the installation

must be inspected regularly (once a year) by a qualified

person. Meanwhile if encounter technical problems, please

ask our after-sales service for advice. If the power supply

cable of the unit is damaged, it must be replaced by the

manufacturer or its after-sales service to avoid all danger.

9257 N150 SANICUBIC NOTICE:5622 NOTICE N°129 EXE 19/11/10 13:36 Page 7

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sanibroyeur SANICUBIC 2 Classic Expert-line Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info