Bedienungsanleitung Scheppach CSD40-20Li (Seite 21 von 88) (Deutsch, Englisch, Französisch, Polnisch)

782591

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58

21 | GB

magnetic eld during operation. This eld can im-

pair active or passive medical implants under certain

conditions. In order to prevent the risk of serious

or deadly injuries, we recommend that persons with

medical implants consult with their physician and the

manufacturer of the medical implant prior to operat-

ing the electric tool

Information on the charging unit and charging

process

1. Observe the data provided on the type plate of

the charging unit. Only connect the charging unit

to the mains voltage provided on the type plate.

2. Protect the charging unit and cable from dam-

age and sharp edges. Have damaged cables re-

placed by an electrician immediately.

3. Keep the charging unit, rechargeable batteries

and rechargeable device out of reach of children.

4. Do not use damaged charging units.

5. Do not use the charging unit supplied to charge

other rechargeable devices.

6. The rechargeable battery pack will heat up with

heavy loads. Leave the rechargeable battery

pack to cool down before starting the charging

process.

7. Do not over-charge rechargeable batteries!

Observe the maximum charging times. These

charging times only apply to discharged bat-

teries. Inserting a charged or partially charged

rechargeable battery multiple times leads to

overloading and cell damage. Do not leave re-

chargeable batteries in the charging unit for mul-

tiple days.

8. Never use or charge rechargeable batteries if

you suspect that they were last charged more

than 12 months ago. The probability is high that

the rechargeable battery is already dangerously

damaged (deep discharge).

9. Charging at a temperature of less than 10°C

leads to chemical damage to the cell and can

result in a re.

10. Do not use rechargeable batteries that have heat-

ed up during charging, because the battery cells

could be dangerously damaged.

11. Do not use rechargeable batteries that are bulg-

ing or deformed, or that exhibit unusual symp-

toms (out-gassing, hissing, crackling, etc.)

12. Do not discharge the rechargeable battery fully

(recommended nal discharge level max. 80%).

Fully discharging leads to premature ageing of

the battery cells.

13. Never leave batteries to charge unsupervised!

Residual risks

The machine has been built according to the state of

the art and the recognised technical safety require-

ments. However, individual residual risks can arise

during operation.

bore into a surface.

8. Additional Safety Warnings

Information on the rechargeable battery

1. The battery pack of the rechargeable device is

not charged when delivered. It is therefore nec-

essary to charge the battery before rst com-

missioning.

2. For optimum battery capacity avoid deep dis-

charge cycles! Charge your battery frequently.

3. Store your battery in a cool place, ideally at 15°C

and with at least 40% charge.

4. Lithium-ion batteries are subject to natural age-

ing. The rechargeable battery must be replaced

no later than when its capacity is just 80% of the

capacity in new condition! Weakened cells in an

aged battery pack are no longer able to cope

with the high capacity requirements and therefore

constitute a safety risk.

5. Do not throw old rechargeable batteries into an

open re. Risk of explosion!

6. Do not ignite or burn rechargeable batteries.

7. Do not deep discharge rechargeable batter-

ies! Deep discharge damages the battery cells.

The most frequent cause of deep discharge in

battery packs is lengthy storage or a lack of use

of partially discharged rechargeable batteries.

End the working process as soon as the capaci-

ty is notably reduced or the protection electronics

trigger. Only store the rechargeable battery after

fully charging.

8. Protect rechargeable batteries or device from

overloading! Overloading quickly leads to over-

heating and cell damage inside the rechargea-

ble battery housing, without overheating being

externally visible.

9. Avoid damage and impacts! Replace recharge-

able batteries immediately if these fall more than

one metre or if they have been exposed to hefty

impacts, even if the battery pack housing ap-

pears undamaged. The battery cells inside may

be seriously damaged. Also observe the disposal

instructions here.

10. With overloading or overheating, the protective

shut-down integrated in the device switches off

for safety reasons. Attention! Do not actuate the

on/off switch again if the protective shut-down

has switched the device off. This can lead to

damage to the rechargeable battery.

11. Only use original rechargeable batteries. The use

of other batteries can lead to injuries, explosion

and a risk of re.

Warning! This electric tool generates an electro-

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Scheppach CSD40-20Li Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info