Bedienungsanleitung Skoda Rapid - 2013 (Seite 182 von 218) (Englisch)

678345

182

Zoom out

Zoom in

Vorherige Seite

1/218

Nächste Seite

›

Insert the adapter

» Fig. 151 with its toothed side fully into the inner toothing

of the safety wheel bolt

until the stop so that only the outer hexagon is jut-

ting out.

›

Push the wheel wrench onto the adapter

up to the stop.

›

Loosen or tighten the wheel bolt » page 178.

›

After removing the adapter, reinstall the full wheel trim or place the cap onto

the anti-theft wheel bolt.

›

Have the tightening torque checked with a torque wrench as soon as possible.

Note

■

Make a note of the code number hammered into the rear side of the adapter or

the rear side of the anti-theft wheel bolt. This number can be used to purchase a

replacement adapter from a ŠKODA Service Partner, if necessary.

■

We recommend that you always carry the adapter for the wheel bolts with you

in the vehicle. It should be stowed in the vehicle tool kit.

■

The anti-theft wheel bolt set and adapter can be purchased from a ŠKODA Part-

ner.



Tyre repair



Introduction

This chapter contains information on the following subjects:

Breakdown kit

181

Preparations for using the breakdown kit

181

Sealing and inflating the tyre 181

Check after 10 minutes' driving

182

Use the breakdown kit to reliably repair tyre damage caused by foreign bodies or

a puncture with diameters up to approx. 4 mm.

A repair made using the breakdown kit is never intended to replace a permanent

repair on the tyre. Its purpose is to get you to the nearest specialist garage.

The wheel must not be removed during repair.

Do not remove foreign bodies, e.g. screws or nails, from the tyre.

The breakdown kit must not be used under the following circumstances.

›

There is damage to the rim.

›

The outside temperature is less than -20 °C.

›

The tears or punctures are greater than 4 mm in size.

›

There is damage to the tyre wall.

›

Driving with very low tyre pressure or with a completely flat tyre.

›

If the use-by-date (see inflation bottle) has passed.

WARNING

■

A tyre filled with sealant has the same driving characteristics as a standard

tyre.

■

Do not travel faster than 80 km/h.

■

Avoid accelerating at full throttle, sharp braking and fast cornering.

■

Check the tyre pressure after driving for 10 minutes.

■

The sealant is hazardous to heath. Remove immediately if it comes into con-

tact with the skin.

For the sake of the environment

Used sealant or sealant whose expiry date has passed must be disposed of in ac-

cordance with environmental protection regulations.

Note

■

Observe the manufacturer's usage instructions for the breakdown kit.

■

A new bottle of sealant can be purchased from ŠKODA Original Parts.

■

Immediately replace the tyre that was repaired using the breakdown kit, or con-

sult a specialist garage about repair options.



180

Do-it-yourself

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid - 2013 Seite 182

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid - 2013

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info