Bedienungsanleitung Skoda Rapid - 2013 (Seite 184 von 218) (Englisch)

678345

184

Zoom out

Zoom in

Vorherige Seite

1/218

Nächste Seite

›

Remove the empty tyre inflator bottle from the valve.

›

Screw the valve core back into the tyre valve using the valve remover

Inflating

›

Screw the tyre inflation hose

» Fig. 152 on page 181 of the air compressor

firmly onto the tyre valve.

›

Check that the air release valve

is closed.

›

Start the engine and run it in idle.

›

Plug the connector

into 12 Volt socket » page 56, 12-volt power outlet.

›

Switch on the air compressor with the ON and OFF switch

›

Allow the air compressor to run until a pressure of 2.0 - 2.5 bar is achieved. Max-

imum run time of 8 minutes »

›

Switch off the air compressor.

›

If you cannot reach an air pressure of 2.0 – 2.5 bar, unscrew the tyre inflation

hose

from the tyre valve.

›

Drive the vehicle 10 metres forwards or backwards to allow the sealing agent to

“distribute” in the tyre.

›

Firmly screw the tyre inflation hose

back onto the tyre valve and repeat the

inflation process.

›

If you cannot reach the required tyre inflation pressure here either, this means

the tyre has sustained too much damage. You cannot seal with tyre with the

breakdown kit »

›

Switch off the air compressor.

›

Remove the tyre inflation hose

from the tyre valve.

Once a tyre inflation pressure of 2.0 – 2.5 bar is achieved, continue the journey at

a maximum speed of 80 km/h (50 mph).

Check the tyre inflation pressure after driving for 10 minutes » page 182.

WARNING

■

The tyre inflation hose and air compressor may get hot as the tyre is being

inflated – there is a risk of injury.

■

Do not place the hot tyre inflation hose or hot air compressor on flammable

materials – there is a risk of fire.

■

If you cannot inflate the tyre to at least 2.0 bar, this means the damage sus-

tained was too serious. The sealing agent cannot be used to seal the tyre. 

Do not drive the vehicle. Seek help from a specialist garage.

CAUTION

Switch off the air compressor after running 8 minutes at the latest – there is a

risk of overheating. Allow the air compressor to cool a few minutes before switch-

ing it on again.



Check after 10 minutes' driving

First read and observe the introductory information and safety warn-

ings on page 180.

Check the tyre inflation pressure after driving for 10 minutes!

If the tyre pressure is 1.3 bar or less

›



Do not drive the vehicle! You cannot properly seal with tyre with the break-

down kit.

If the tyre pressure is 1.3 bar or more

›

Adjust the tyre inflation pressure to the correct value (see inside of fuel filler

cap).

›

Continue driving carefully to the nearest specialist garage at a maximum speed

of 80 km/h (50 mph).



Jump-starting



Introduction

This chapter contains information on the following subjects:

Jump-starting using the battery from another vehicle

183

Jump-starting in vehicles with the START-STOP system

184

WARNING

■

A discharged vehicle battery may already freeze at temperatures just below

0 °C. If the battery is frozen, do not jump start with the battery of another ve-

hicle – there is a risk of explosion.

■

Pay attention to the warning instructions relating to working in the engine

compartment » page 155.





182

Do-it-yourself

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid - 2013 Seite 184

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid - 2013

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info