Bedienungsanleitung Spektrum DX8 (Seite 13 von 100) (Englisch)

708059

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite





With the transmitter on and the main or telemetry screen displayed, press the

roller. The Function list displays.

Rotate the roller to highlight Swashplate then press the roller to access.



Highlight the desired function (Aileron, Elevator or Pitch) then press the roller to

access.

Rotate the roller to change the Swashplate value. (Positive and negative values are

available and allow you to reverse that function.) Press the roller to accept. Repeat

the above process for all three cyclic inputs (aileron, elevator and pitch).

Swashplate values increase or decrease the overall control travel of the

selected channel. For example if you increase Pitch value, the travel of all three

servos that control pitch increases. If you increase aileron value, the aileron and

pitch servos increase. Increasing or decreasing this value affects the travel of that

function and not the individual servo.



Rotate the roller to highlight EXPO then press the roller to toggle between Inh and

Act. Note: Swash EXP compensates for the non-proportional rotational output of

the servo arms. We recommend you always have this activated.



Highlight E-ring then press the roller to toggle between Inh and Act.

STEP #7



The Dual Rate and Exponential functions allow you to program up to three control

rates and select them independently or with a single switch. Dual Rates and

exponentials are available on the aileron, elevator and rudder channels. Positive

expo values reduce control sensitivity around center with no effect on maximum

travel. We recommend using positive values. Negative exponential values

increase sensitivity around neutral and are seldom used.



In the Function List rotate the roller to highlight D/R and Expo. Then press the

roller to access the D/R and Expo screen.



Rotate the roller to highlight the channel function, then press the roller to select

the function. Next rotate the roller to select the aileron, elevator or rudder channel.

Then press the roller to accept that channel.



Rotate the roller to highlight SW (switch) at the bottom of the screen then press

the roller to access the switch options. Rotate the roller to select the desired

switch then press the roller to activate that switch.

 By assigning multiple channels to the same switch, you can use a single

switch to affect the dual and exponential rates of multiple channels.



Move the switch displayed at the bottom of the screen to change the Pos to one

of its three positions. When you make D/R or Expo adjustments, the values are

assigned to the presently selected position and are automatically active when the

switch is in that position (Pos 0, 1or 2).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spektrum DX8 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spektrum DX8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info