Bedienungsanleitung Spektrum DX8 (Seite 15 von 100) (Englisch)

708059

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite





Highlight EXPO then press the roller to toggle between the activate and inhibit

settings.

STEP #10



The Gyro function allows you to program the adjustment of up to four gyro gain

values from a variety of switches including the ﬂight mode switch. You can select

the channel the gyro gain is on.



In the Function List rotate the roller to highlight Gyro. Press the roller to access

that screen.



To activate the Gyro function, highlight Inhibit, then press the roller to access the

switch function. Rotate the roller to access the desired gyro control switch. Press

the roller to accept the gyro control switch and access the Gyro gain screen



You can assign the receiver channel the gyro gain is plugged into in this screen.

The governor and the gyro must use two different channels. If the governor

function uses a channel, it will not appear in the gyro list.

Highlight Ch: (channel) then press the roller to access the gyro channel function.

Select the desired channel to plug the gyro gain into and press the roller to accept

the switch. Normally the Gear channel is used.



Rotate the roller to select the desired gain value then press the roller to select the

gain value.

 The displayed value is the corrected gyro value. 0% represents 1.500ms or

OFF with most gyros.

Repeat this for all desired Gain values.

STEP #11



The Governor function adjusts engine rpm when using a Governor or throttle

limiter. You can program the selection of up to four governor values from a variety

of switches including the ﬂight mode switch. Also you can select the channel the

governor controls.

In the Function List rotate the roller to highlight Governor then press the roller to

access that screen.



The Governor function defaults to Inhibit. To activate the Governor function, rotate

the roller to highlight Inhibit; then, press the roller to select the desired control

switch by rotating the roller. Afterwards, press the roller to accept the switch

choice and enter the governor screen.



In this screen you can assign the receiver channel the Governor is plugged into.

The governor and the gyro must use two different channels. If the gyro function

uses a channel, it will not appear in the governor list.

Rotate the roller to highlight Ch: (channel) then press the roller to access that

function. Select the desired channel to plug the governor in to and press the roller

to accept the channel. Normally Aux 2 is used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Spektrum DX8 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Spektrum DX8

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info