Bedienungsanleitung Yamaha S90ES (Seite 182 von 204) (Englisch)

587008

182

Zoom out

Zoom in

Vorherige Seite

1/204

Nächste Seite

About MIDI

182

Owner’s Manual

Appendix

NRPN (Non Registered Parameter Number) LSB

(Control Change #098) (only for Plug-in Board)

NRPN (Non Registered Parameter Number) MSB

(Control Change #099) (only for Plug-in Board)

Messages which adjust a voice’s vibrato, ﬁlter, EG, drum

setup or other parameter settings.

First send the NRPN MSB and NRPN LSB to specify the

parameter which is to be controlled. Then use Data Entry

(page 181) to set the value of the speciﬁed parameter.

Note that once the NRPN has been set for a channel,

subsequent data entry will be recognized as the same

NRPN’s value change. Therefore after you use the RPN,

you should set a Null (7FH, 7FH) value to avoid

unexpected results. For details, refer to the owner’s manual

of the relevant Plug-in Board.

RPN (Registered Parameter Number) LSB

(Control Change #100)

RPN (Registered Parameter Number) MSB

(Control Change #101)

Messages which offset, or add or subtract values from a

Part’s pitch bend sensitivity, tuning, or other parameter

settings.

First send the RPN MSB and RPN LSB to specify the

parameter which is to be controlled. Then use Data

Increment/Decrement above to set the value of the

speciﬁed parameter.

Note that once the RPN has been set for a channel,

subsequent data entry will be recognized as the same

RPN’s value change. Therefore after you use the RPN, you

should set a Null (7FH, 7FH) value to avoid unexpected

results. The following RPN numbers can be received.

■ Channel Mode Messages

All Sound Off (Control Change #120)

Clears all sounds currently sounding on the speciﬁed

channel.

However, the status of channel messages such as Note On

and Hold On is maintained.

Reset All Controllers (Control Change #121)

Resets all controllers to their initial values.

All Notes Off (Control Change #123)

Clears all notes currently on for the speciﬁed channel.

However, if Hold1 or Sostenuto is on, notes will continue

sounding until these are turned off.

Mono (Control Change #126)

Performs the same operation as when an All Sound Off

message is received. If the 3rdbyte parameter (the

parameter that determines the mono number) is 0 - 16 the

parts corresponding to those channels are set to mono.

Poly (Control Change #127)

Performs the same operation as when an All Sound Off

message is received, and sets the parts corresponding to

those channels are set to poly.

RPN MSB RPN LSB Parameter Name

00H 00H Pitch Bend Sensitivity

00H 01H Fine Tune

00H 02H Coarse Tune

7FH 7FH Null

2nd BYTE 3rd BYTE MESSAGE

120 0 All Sound Off

121 0 Reset All Controller

123 0 All Notes Off

126 0 –16 Mono

127 0 Poly

Controller Initial Value

Pitch Bend 0 (center)

Aftertouch 0 (min)

Modulation 0 (min)

Expression 127 (max)

Breath Controller 127 (max)

Foot Controller 127 (max)

Assign A 0 (center)

Assign B 0 (center)

Assign 1 0 (center)

Assign 2 0 (center)

Sustain Switch 0 (off)

Sostenuto Switch 0 (off)

RPN Number not speciﬁed; internal data

will not change

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Yamaha S90ES Seite 182

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Yamaha S90ES

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info