Bedienungsanleitung Satel CA-10 (Seite 9 von 43) (Englisch)

699577

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

CA-10 Installer Manual 7

33 – arm/disarm/clear alarm – the output signals the performance of particular operations with,

respectively, one, two, or four pulses 0.16s each.

34 – keypad buzzer alarm – silent alarm signaling in the partition keypad.

35 – power supply on armed mode – it functions similarly to the arm status output, but goes on right

after starting the exit delay countdown, not after changeover from the exit delay to the armed mode

(it can be used, for example, as indicator or power supply output for microwave detectors in spaces

where people stay).

36 – LED status – the output can control a LED to indicate the following statuses:

- off – control panel disarmed

- steady light – control panel armed

- blinking light – the control panel armed, there was alarm or trouble

Note: If in the armed mode any zones are violated in the system, the LED will be blinking

and will only change to steady light after the violation ends.

.37 – RELAY status – the output can control a relay. The output becomes active after arming, and inactive

after an alarm is triggered, a trouble occurs, or the system is disarmed.

Note: If in the armed mode any zones are violated in the system, the output will become

active after the violation ends.

38 – zone trouble – the output signals that the maximum zone violation time or the maximum zone no

violation time have been exceeded.

39 – no guard code – the output is activated by a timer programmed as the partition control TIMER,

unless a guard code is entered within the timer specified time.

40 – service mode status – the output is activated if the control panel service mode has been called from

any keypad.

41 – battery test result – the output whose state is updated after each battery voltage test.

Partitions

Creation of a partition consists in assigning at least 1 zone to it. The CA-10 permits

4 partitions to be created. Any outputs, telephone numbers and pager messages can be

assigned to one partition, thus enabling four independent alarm systems to be built on the

basis of one CA-10 control panel.

In the event of a few keypads being connected to the control panel, each keypad will be

hooked up to the particular partition via a special control output. The keypad connected to the

CLK1 output will belong to the partition 1, that connected to the CLK2 output – to the partition

2, etc.

Where the system comprises less keypads than partitions, individual partitions can be

operated from the existing keypads, by means of the GO TO function (when this function is

called, the keypad will for a time belong to another partition). The partition which has no

keypad, can be controlled through the zones to which the "arming" and "disarming" functions

are assigned. The state of such a partition can be signaled on the outputs.

Partitions can be defined in the following way:

• partitions have no common zones – they are independent sub-systems,

• some zones belong to several partitions – the common zones are only armed when all

the partitions these zones belong to are armed,

• all zones of one partition belong at the same time to another partition – the control

panel recognizes one partition as the master, and the other as an internal one;

arming/disarming the master partition results in simultaneously

arming/disarming the

internal partition, while arming/disarming the internal partition only affects the zones within

that partition,

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Satel CA-10 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Satel CA-10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info